Striper Talk Striped Bass Fishing, Surfcasting, Boating - View Single Post

MAC · 09-22-2006, 04:57 PM

Jet 1236 lathe. 3/4 hp. Duplictor is a delta with a custom template holder. There are 2 sorby steb centers and a ball bearing live center. There is also a chuck for thru drilling. It has a carbide cutter. There are 24 templates as well as the blanks for setting most of the templates up on duplicator. If purchased new it would cost you over 1600 without the templates. I want $1150 /OBO and will deliver within a reasonable distance.

Sorry I can't ship this either as it is really heavy. (probably weighs 400#s) ould explain the picture below to any potential buyer. The duplicator is set up on the bac side of the lathe so you can work off of the front without removing the duplicator. I will also show the buyer how to set it up .

09-22-2006, 04:57 PM	#1
MAC Registered User iTrader: (0) Join Date: Jul 2002 Location: Maine Posts: 4,547	Lathe Jet 1236 lathe. 3/4 hp. Duplictor is a delta with a custom template holder. There are 2 sorby steb centers and a ball bearing live center. There is also a chuck for thru drilling. It has a carbide cutter. There are 24 templates as well as the blanks for setting most of the templates up on duplicator. If purchased new it would cost you over 1600 without the templates. I want $1150 /OBO and will deliver within a reasonable distance. Sorry I can't ship this either as it is really heavy. (probably weighs 400#s) ould explain the picture below to any potential buyer. The duplicator is set up on the bac side of the lathe so you can work off of the front without removing the duplicator. I will also show the buyer how to set it up . Attached Thumbnails Last edited by MAC; 09-24-2006 at 11:37 AM..