View Single Post
Old 12-17-2006, 11:45 PM   #2
stripercrazy
Hernia Pikie Maker
 
Join Date: Jun 2001
Location: e. prov r.i.
Posts: 1,176
drilling

on the lathe,5/32....1/2 inch chuck with morse taper#2 arbor....drill both sides and finish with 6 inch drill bit(brad point)in a hand drill. when you drill a off centered plug like most swimmers (lip slot center)I allway drill the body upside down both sides......you can't switch. I got my chuck and arbor at woodcrafters, you can find the bits anywhere..ed

its no ones fault
stripercrazy is offline   Reply With Quote