1. Cut stock to length
2. Thru drill
3. Turn
4. Sand
5. Drill belly weight hole
6. Drill belly swivel hole (If 2 add one more step)
7. Drill 1 eye
8. Drill other eye
9. Drill tail weight hole
10. Cut excess stock off front end of plug
11. Cut excess stock off of tail end
12. Insert belly weight
13. Fill belly weight hole
14. Sand belly weight hole flush
15. Drill nose grommet hole wider to accomodate nose grommet
16. Seal
17. Prime
18. Sand
19. Paint
20. Add eyes
21. Clear coat
22. Add belly grommet (If 2 belly grommets add another step)
23. Add nose grommet
24. Insert wire
25. Add swivel as wire passes through plug (If 2 swivels add another step)
26. Add tail weight
27. Add tail grommet
28. Bend and loop tail wire
29. Put split ring on belly swivel (If 2 belly swivels add another step)
30. Add hook to belly split ring (If 2 belly swivels add another step for 2nd hook)
31. Put split ring on tail loop
32. Put hook on tail split ring
This is a basic case scenario building a basic plug......there are many other steps given the particular plug one is building but there is an incredible amount of time involved, as Capesams states, in building a plug. If you are doing say 100 of the same plug, sure you do each step 100 times each step all at one time, one step at a time but its still alot of time be it 1 plug or 500 plugs. I estimate there are a minimum of 40 steps to each plug I make and there are a few more steps I do in regards to sanding eyes if I need to round them down smooth....I admit to being a fanatic. Slice it up any way you want......they take a boat load of time to make if made correctly.
