|
Wayyyy to complicated!!
Take a straight piece of coat hanger wire. bend a hook on one end and make a wave on the other end. Shove the wire into the through hole until is jams tight. Use this wire all the way from dipping in sealer to applyitn epoxy.
Sealer, you dip, wide, hang.
Prime, you spray and hang.
Top coat, you spray6 and hang.
Epoxy, you apply epoxy and clamp the wire in your vise with the plug on end facing up. Leave it there until you have the next plug done and need the vise. Hang the first plug and clamp the second.
After epoxy dries pull the wire inprep for adding hardware.
You only need to flip once with 2-Ton!
|