Striper Talk Striped Bass Fishing, Surfcasting, Boating - View Single Post

Diggin Jiggin · 02-20-2007, 01:05 PM

I've been pouring them into wooden molds but then you gotta cut them to fit and when I cut them I end up pinching the thru wire hole and then I gotta drill them again to reopen the hole. Then I gotta cut them to length. If I pour teh same diameter as the hole and the hole gets full of sealer then its too tight a fit.

I was just hoping to drill the holes to the right depth, put in a wire, pour into the plug, pull the wire and be done. Plus that way I could make whatever diameter hole I wanted.

You guys have not discouraged me anough, I may still play around with this.

02-20-2007, 01:05 PM	#7
Diggin Jiggin Registered User iTrader: (0) Join Date: Nov 2004 Location: plymouth,ma Posts: 1,142	I've been pouring them into wooden molds but then you gotta cut them to fit and when I cut them I end up pinching the thru wire hole and then I gotta drill them again to reopen the hole. Then I gotta cut them to length. If I pour teh same diameter as the hole and the hole gets full of sealer then its too tight a fit. I was just hoping to drill the holes to the right depth, put in a wire, pour into the plug, pull the wire and be done. Plus that way I could make whatever diameter hole I wanted. You guys have not discouraged me anough, I may still play around with this.