Quote:
Originally Posted by Diggin Jiggin
George, I remember watching him do that also. I was looking at those online this weekend. I'm not sure which if any of the models would fit on a delt midi or if they are worth the money or what bits they need?
I've been messing around with the offcenter stuff and it's very hard without a duplicator. You need to unchuck the piece and do each side separately, and without a duplicator its hard to get the 2 sides to match. After 2 or 3 I finally figured out if I take the same number of passes on each side and try to take the same amount off each time they come out pretty close, but sometimes with swimmers close is not good enough...
|
I have the Penn State one and it does the Job. Its a good duplicator
if you are on a budget. I push the cutter to the side and round out the
wood with a gouge.