|
I have about a gallon and then some of watery thin(as compared to e-tex or devcon) boat building epoxy and an oven to heat the blanks. Would that work?
I have a few questions for you guys that do the epoxy thing. The big one is how do you coat the outside AND the throughhole and still have a way to hang it to cure? The other question is do you just use a bunch of epoxy and spin it like you would for a finish coat or do you try and get as thin a coat as possible? Also, could I use the boat building epoxy for a finish coat too, or am I better off sticking to e-tex and devcon?
I know I'm asking a lot of questions and I should just experiment but it can't hurt to get some advice from folks that have done it before.
|