Striper Talk Striped Bass Fishing, Surfcasting, Boating - View Single Post

Slipknot · 01-12-2003, 10:56 AM

Very Nice Fred. I'll be getting some of those bits it looks like

Bob T. I have a spade(or paddle ) bit that BM ground down to a crurve or radius on the sides with a gringing wheel. Be sure to keep an angle on the edge so it will cut still. It's not that hard to do.

01-12-2003, 10:56 AM	#8
Slipknot Super Moderator iTrader: (0) Join Date: Aug 2000 Location: Middleboro MA Posts: 17,125	Very Nice Fred. I'll be getting some of those bits it looks like Bob T. I have a spade(or paddle ) bit that BM ground down to a crurve or radius on the sides with a gringing wheel. Be sure to keep an angle on the edge so it will cut still. It's not that hard to do. Last edited by Slipknot; 01-12-2003 at 10:59 AM..