i was building a small shelf ok
and i needed a small length of 2 x 4
with a 45' degree angle cut on each end
for a brace support.
so i'm thinkin
...this is a job for the chop saw
and i grab it from underneath the bench
to make short work of the job.
then i decide to clean out the sawdust chute
and not spray it every where and i go to
clean out some kind of clog or obstruction
i see in the end of the shoot...
i stick my finger in the hole and try to dig
it out but it's wet and kinda slimey and
stuck
and it just won't budge... then i said???
WTF is that?
feeling kinda grossed out
now...
and out hopes a toad
out of it-> onto the floor
much to my astonishment... LOL