Striper Talk Striped Bass Fishing, Surfcasting, Boating - View Single Post

bud8fan · 02-16-2003, 12:48 PM

Go to this page and scroll down to where it says
Stripper blots/Shoulder screws by Unbrako.

The pic to the right is what they are like except for size that is

I used a screw with a .312 diameter and .375 shoulder with 1/4-20 threads.
The screw is high speed steel and it locks down against the aluminum support. The nylon wheel was drilled to about .315 and has a stainless washer on each side of it.
There is no way the roller would ever seize as far as I can see!
Also if you want it faster you can always put a VERY SMALL drop of light oil(rocket fuel) or some teflon spray onto the shoulder.

here is the webpage. It will open in Adobe Acrobat!

Hope this gives you a better understanding on how the bolt works!

http://www.mscdirect.com/PDF.process?pdf=1943&Keyword=Y

Russ

02-16-2003, 12:48 PM	#25
bud8fan Guest iTrader: (0) Join Date: Mar 2002 Location: RI Posts: 815	Chris, Go to this page and scroll down to where it says Stripper blots/Shoulder screws by Unbrako. The pic to the right is what they are like except for size that is I used a screw with a .312 diameter and .375 shoulder with 1/4-20 threads. The screw is high speed steel and it locks down against the aluminum support. The nylon wheel was drilled to about .315 and has a stainless washer on each side of it. There is no way the roller would ever seize as far as I can see! Also if you want it faster you can always put a VERY SMALL drop of light oil(rocket fuel) or some teflon spray onto the shoulder. here is the webpage. It will open in Adobe Acrobat! Hope this gives you a better understanding on how the bolt works! http://www.mscdirect.com/PDF.process?pdf=1943&Keyword=Y Russ