Quote:
Originally Posted by scottw
..when you guys have problems with "that clear coat between the paint and finish epoxy"..is it a problem getting the epoxy to lay out well on the plug an over a scratch coat or is it an issue later discovered with poor adhesion and peeling?just curious, I realize that there are a whole host of things that can go wrong...."
|
When things peeled on me, the failure was between the createx and the primer, the epoxy stayed stuck to the createx ok. Hasn't happened since I changed my primer to ZSpar undercoat......though I'm starting to wonder why I just don't prime with white createx after sealing and eliminate a step.
When the epoxy/scratch coat stuff went bad, it was an adhesion problem with the epoxy pulling away in spots (system three claimed it was because of "wetting agents" in the scratch coat). It is less of an issue over just the createx, but still occurs if any oil or silicone gets into the process (like on your brush, mixing stick, mixing cup, measuring syringes, hands, or thru God's wrath....so go to church). System Three Clear Coat was the fussiest, probably because it is the thinnest of the epoxies I tried.