|
I use the bandsaw and when its adjusted right it cuts slots that fit the thin lips. I got some danny2's from nj tackle that are a bit thicker that I use on my fat danny's and those you need to cut twice.
Bruce if you are epoxying first and the thru hole gets blocked. if you just take a piece of your thru wire and hold the end in a candle till its orange, just pass it thru and it will melt right thru the block. I had that problem on some that I epoxy sealed and I was worried that If I redrilled I may drill thru the sealed part and leave open some raw wood but the heated thru wire worked great.
|