[VTBasser]

Exactly how do folks heat set Createx Airbrush paint and when or how do you know the process is done?

I have tried various amounts of heating with my 1200W hair drier and I am still able to remove the paint with water and a little rubbing.

Can you cure it with heat where a molecular bond occurs between the paint and primer and the paint with itself?

Does Createx Airbrush paint ever cure to the point that you can't wash it off?

Can you cure it with a 1200W hairdryer on high moving it around the plug for 5 minutes or so? Is a 1200W dryer not enough? Or do you use low and hold it in place for a while then move on to the next spot? Or do you have a heated box or a toaster oven and hold some temperature for a given time?

Supporting information: I Minwax Helmsman Spar Urethane seal, BIN red label can prime (not spray), and paint with Createx Airbrush paint.

Thanks for the help!