Quote:
Originally Posted by numbskull
|
I swear by this stuff now.
All my rods have it (a couple I just got will have it very soon).
CMS carries it.
Quote:
Originally Posted by nightfighter
Not to hijack, but my cork is worn away to bare blank above the reel seat (where I hold the braid with finger when casting). Will shrink wrap pass over the seat? Or should I just wrap with tape, or raquet grip replacement?
|
Conventional.... probably not if it has a trigger, spinning, yes. The starting diameter is more than enough.
Take some measurements if you want to do it yourself and bring em down to CMS, they're very very helpful.
A hair dryer works fine, heat gun (VERY CAREFULLY) even better to shrink it down.