Quote:
Originally Posted by ProfessorM
I would still build a pvc frame under it. I have a custom cover that came with boat but if I just put it on it would get full of snow in low spots and rip sure than sh((*^&*t. With snow I need the extra support. Mine is a walk around though.
|
Quote:
Originally Posted by PRBuzz
I did the custom cover from here and has only gone through a single winter but no problems with the snow etc. The snow slides right off and with any sun the heat builds up under the cover to melt the remainder. This is a breathable cover so no moisture buildup inside however in a pounding downpour water will penetrate as with any water-resistant synthetic. I can easily put on/off by myself. My cover has a zipper on either side so as to permit easy access into the boat whenever I want.
I also attached a couple small solar panels (one to each battery) to keep batteries charged throughout winter (I don't remove from boat nor did I disconnect).
|
Paul, I saved the 1X3 ridge pole and supports from last year to support the new cover. Hopefully the most I would have to do is shorten the supports to fit the cover.
Buzz, did you get your cover from the same outfit I mentioned? Which material did you opt for? I like the solar panel idea. Where did you get them?