Thread: I'm thinking bandsaw ....
View Single Post
Old 12-27-2009, 08:33 PM   #6
nightfighter
Seldom Seen
iTrader: (0)
 
nightfighter's Avatar
 
Join Date: May 2001
Posts: 10,543
Quote:
Originally Posted by Jigman View Post
I did something similar on a freshwater plug using a drum sander in the drill press. Mark the center line on the top and place a line on the sides where you want the cut. Go slow and join the lines. Finish up by hand with sandpaper.

Jigman
I have a drum sander that fits on the Shopsmith lathe. Can your lathe accept one Eddie?
“Americans have the right and advantage of being armed, unlike the people of other countries, whose leaders are afraid to trust them with arms.” – James Madison.
nightfighter is offline   Reply With Quote