Striper Talk Striped Bass Fishing, Surfcasting, Boating - View Single Post

Crafty Angler · 01-01-2010, 11:03 PM

Started on my off season to-do list this afternoon and needed to replace the studs on my K5000's - only snapped off half of them with a rachet since they were seized up...

Tried a Google search for a tool/bit called a Grabber to remove the threaded remnants and couldn't find it, it's used for removing stripped screws, etc

Any machinists in da house with suggestions...

Of course, I suppose if I'd taken all the studs out and sprayed 'em with Neverseize like I'd planned this would have been a little easier...

01-01-2010, 11:03 PM	#1
Crafty Angler Geezer Gone Wild iTrader: (2) Join Date: Nov 2001 Posts: 3,397 Blog Entries: 2	Korker Replacement Stud Question Started on my off season to-do list this afternoon and needed to replace the studs on my K5000's - only snapped off half of them with a rachet since they were seized up... Tried a Google search for a tool/bit called a Grabber to remove the threaded remnants and couldn't find it, it's used for removing stripped screws, etc Any machinists in da house with suggestions... Of course, I suppose if I'd taken all the studs out and sprayed 'em with Neverseize like I'd planned this would have been a little easier...
	"There is no royal road to this heavy surf-fishing. With all the appliances for comfort experience can suggest, there is a certain amount of hard work to be done and exposure to be bourne as a part of the price of success." From "Striped Bass," Scribner's Magazine, 1881.