Striper Talk Striped Bass Fishing, Surfcasting, Boating - View Single Post

MAC · 04-13-2003, 04:33 PM

I guess I should have said what kind it is. I got it from Penn State Industries. It is made to fit their Carba-tec lathe. I had to modify it slightly (cut one little corner) so it would fit properly. Cost around $120. Gotta go get more wood this week. It goes fast with one of these. They say you can use an original turning but it only has a 1" throw, so I made some templates out of 1/8" aluminum flatstock

04-13-2003, 04:33 PM	#5
MAC Registered User iTrader: (0) Join Date: Jul 2002 Location: Maine Posts: 4,547	I guess I should have said what kind it is. I got it from Penn State Industries. It is made to fit their Carba-tec lathe. I had to modify it slightly (cut one little corner) so it would fit properly. Cost around $120. Gotta go get more wood this week. It goes fast with one of these. They say you can use an original turning but it only has a 1" throw, so I made some templates out of 1/8" aluminum flatstock Last edited by MAC; 04-13-2003 at 04:37 PM..