Quote:
Originally Posted by Back Beach
1. Round nose pliers...will any pair do, or is there a preferred maker? I saw some in Netcraft for about $20 and as wondering if they're any good.
2. Wire hole diameter...I just ordered a bunch of pre bent wire and would like to know how big a through hole guys typically drill. Is it a one size fits all? I was looking at 1/8" bits to purchase.
3. Metal lips...do you epoxy them in, or does the through wire hold them in place? I have a couple metal lips built by so called "pros" that swim around in the lip slot.
Thanks,
The Ding Dong
|
1. I ground my own out of a pair of good sized needlenose, only one jaw is round. There is an advantage to that.
2. I use 3/16 from the back and 1/8 from the front
3. Tight wire and a 1/8 hole holds them, then I epoxy after they are wired and that helps too.