Quote:
Originally Posted by ProfessorM
Diggin i don't find the single blade i had to cut the right angle flat at the top of the lip to be wide enough. The dado allows me to get that width and more. It is all coming off in the second angle cut anyway. I use it adjusted to the thinnest setting. If it went thinner I would do so. I don't understand why I would want it wider either as I said it will all come off after in the second cut and that will dictate the final width. I just want that width to be a little wider than my single blade will give me. Also i am using it because it is the sharpest blade I got.
I saw Joe's fixture in person and it is a great fixture. I used some of his ideas in mine. I will end up using something similar for my next procedure. I just feel I will get more consistency in my first cut with the set up I am using now. I don't have the type of set up Joe has for his band saw so that is why I opted to go this route. I also find it not to be too messy as it is a very small cut and not much dust and it is pretty safe, at least for me, as the blade is only a small amount above the table. Of course you need to pay attention and accident's can happen to the best of us. I still may add an adjustable miter groove set up for futher saftey but for now I will use as is.
|
I hear ya Paul, with out a large table and fence, my set up is worthless...ya gotta do with what ya have and feel comfortable with... over 25 years ago, I saw a good friend loose 3 fingers to a table saw while we were putting an addition on his house... to this day, every time I hear the high pitch whine of a table saw, a chill goes down my spine..