Striper Talk Striped Bass Fishing, Surfcasting, Boating - View Single Post

nightfighter · 02-17-2010, 02:37 PM

Thanks, guys. I have found a 48" jig I have used before, after rummaging around the mess my shop has evolved into... even has 1/4" dowels on either end to hold in line. Of course the only depth collar that is not in my index is the 1/4 5mm that I need. So I cut off a short length of 3/4" dowel, bored through the center, and used it to stop the bit at the proper depth.

I appreciate all your help and suggestions, but as Slipknot knows, when you have a dozen floor to ceiling bookcases to build, this is a time killer... I was just hoping to find a 13 hole line borer that would allow all the holes to be drilled in less than five minutes per bookcase.

02-17-2010, 02:37 PM	#6
nightfighter Seldom Seen iTrader: (0) Join Date: May 2001 Posts: 10,543	Thanks, guys. I have found a 48" jig I have used before, after rummaging around the mess my shop has evolved into... even has 1/4" dowels on either end to hold in line. Of course the only depth collar that is not in my index is the 1/4 5mm that I need. So I cut off a short length of 3/4" dowel, bored through the center, and used it to stop the bit at the proper depth. I appreciate all your help and suggestions, but as Slipknot knows, when you have a dozen floor to ceiling bookcases to build, this is a time killer... I was just hoping to find a 13 hole line borer that would allow all the holes to be drilled in less than five minutes per bookcase.
	“Americans have the right and advantage of being armed, unlike the people of other countries, whose leaders are afraid to trust them with arms.” – James Madison.