Quote:
Originally Posted by numbskull
No, I didn't. My weights are high (3/4" x 3/8" I think) and drilled thru. I don't, however, think that the location of the belly weight makes much difference in roll (I could easily be wrong). I think most of it is from the width of the lip and line tie location.
Those lefty lips hanging low below the chin seem to create a lot of roll in thin swimmers. I wouldn't sweat it, however. Your plug is very close to the ones I've been fishing for the last 4-5 years. They are so unstable they will barrel roll with a twitch, and most won't stay on top like I had intended (altough widening the belly a bit changes that), but man oh man do they fish well in quiet water and have taken several fish over 40 lbs (there is a pic of one in this past years fish/plug thread) as well as a handful of fish in the thirtys.
I've found that solid white or solid purple fish particularly well.
You may have trouble keeping them slow enough with spinning tackle.
Skinny is good. I think mine are mostly about 1.17" mid section, but I've built several closer to 1.25 that swim much better (on top) with a little less weight (1/2 x 3/8 I think) and have proven better daytime plugs. At night I stick with the unstable slightly subsurface stuff....and don't have any reason to change.
|
Interesting info. Did you tail weight the slimmer version you made? I tapered the tail down rather then weight it. I made some tail weighted last season and preferred them as the plug swam a little more level. Although the non tail weighted version seemed a little better in stirred up conditions as the lip was able to bite better being faced down. Both had their place.
I was actually thinking of bumping up the lip a little more then original 1/16". maybe getting a few pre-bent lefty lips from M&D's would allow it be bent lower leaving less hanging below the plug. Just a thought.