Quote:
Originally Posted by bennyraw
I start my through hole on the lathe and finish with the hand drill, just like you would on a round blank. If you mark your centers the holes should line up. I don't usually use grommets on hand carves but there are some smaller belly grommets available.
|
I can't do that Benny on these. The wood is a thin rectangle and I have to cut the shape out first. I use a template to draw the basic design.
I may need to shorten the lip slot a hair and try to drill a more straight line to center instead of trying to pass over the lip at an angle. This is tougher than doing a swimmer, lol.
I don't want to use a grommet, I just wasn't sure what bit is right for a hook hanger. Never made one before. Gonna make a little jig to bend some wire cut-off's I have.