Striper Talk Striped Bass Fishing, Surfcasting, Boating - View Single Post

Eric Roach · 10-04-2012, 08:26 AM

I've been using this stuff for about 3 months, and I like it.

The method I use for general filling of pits, etc is to apply Timbermate to the blank while it is still on the lathe (post-sanding). After sanding the filler I apply the pencil marks.

Because Timbermate is water-based, the solvents in the sealer do not dissolve it (and the sealer still penetrates well).

The first coat of primer rarely shows any pits following this process.

10-04-2012, 08:26 AM	#1
Eric Roach Big E Join Date: Dec 2009 Location: Seabrook, NH Posts: 681	Timbermate Wood Filler I've been using this stuff for about 3 months, and I like it. The method I use for general filling of pits, etc is to apply Timbermate to the blank while it is still on the lathe (post-sanding). After sanding the filler I apply the pencil marks. Because Timbermate is water-based, the solvents in the sealer do not dissolve it (and the sealer still penetrates well). The first coat of primer rarely shows any pits following this process. Last edited by Eric Roach; 10-04-2012 at 08:34 AM..