|
I am a little confused with your question so this is my process, hope it helps. I don't use the sq ends when I build. Some do, some don't. Before I take plug out of lathe after final sanding I mark where everything is going to be on plug with pencil and then turn on lathe and mark the spots around the whole plug. Off lathe then thru holes are done. Then sq ends are cut off. Hydro is then done if one chooses to do. I feel darters benefit from this process. Then plug goes into a V block type jig and belly holes are drilled according to the hydro mark. Then I use the belly holes for everything else like slopes, flats, belly wgts., lips slots, eyes, etc... . All my fixtures use the belly holes for orientation. I do eyes with hand drill and forstner bit on the marks made from the pencil marks before it came off lathe. Hope that helps. Paul
|