|
I had done this many time when i first started to epoxy. It will work however ther are a few notables.
Make sure you didnt hit the pain if you did use a clear, i prefer valspar.
If not scuff well using 1k wet but use it dry, feather the edges of the chips thats important when using the epoxy to level the surface.
Wipe down with denatured alcohol. I put them in the spinner for 24 hours with heat to ensure they are dry and warm.
I mix my epoxy warm so its easier to work i use a really thin coat and observe where the low spots are, hot it with some fast heat after working it in and let it spin for about 15 min it wilm start to tack up
Apply a second coat and work the low spots well to level it off.
Posted from my iPhone/Mobile device
|