Repeat the process witht he rear blank, marking out a 5" section and rounding it out to 7/8".. the rear taper starts 1" from the front of the rear half and gradualy tapers to 7/16" at the tail...
After sanding, make a mark at 5/8" ( rear "v"cut) and 1" for your rear belly hook..
proceed to your drill prss and drill your belly holes, they should extend approx. half way through the plug, I use a step( multidiameter) drill for this, so it's a one shot deal, I had the size written down but somewhere misplaced it... if anyone is iterested i can give you the size, it fits the .341 belly gromet perfectly...
Lacking the step drill, use a 1/2" forshner bit to spot face the gromet, then finish with a 3/8 forsner bit...repeat for the rear section..
Continued in the next frame:
|