Striper Talk Striped Bass Fishing, Surfcasting, Boating - View Single Post

Rockfish9 · 03-19-2009, 10:08 PM

allow the plugs to cure for 24 hours before you mess with them, yes they will be dry, but full cure on etex is 72 hours...

to make the fins and tail..

I start with about a 2" section of .030 stainless wire , I wrap it around a 00 phillps and wind it up...

I cut ach "fin:" to about 3/4" and the tail about 1"...

start by ch#^&#^&#^&#^&#^&g a fin (or tail) "bone" in the vise, wrap the shank with thread secure with a half hitch and coat with sally hansens hard as nails...

03-19-2009, 10:08 PM	#26
Rockfish9 Registered User iTrader: (0) Join Date: Jan 2007 Location: Reading Mass/Newburyport/merrimack river Posts: 3,740	allow the plugs to cure for 24 hours before you mess with them, yes they will be dry, but full cure on etex is 72 hours... to make the fins and tail.. I start with about a 2" section of .030 stainless wire , I wrap it around a 00 phillps and wind it up... I cut ach "fin:" to about 3/4" and the tail about 1"... start by ch#^&#^&#^&#^&#^&g a fin (or tail) "bone" in the vise, wrap the shank with thread secure with a half hitch and coat with sally hansens hard as nails... Attached Thumbnails
	A good run is better than a bad stand!