|
If cover is same size then it seems like there is a misalignment of the throw on the drain throw. When have wholen shabang out there should be 2 nuts that counter tighten to give u the right length between the bell that sits/ seals and the handle. Take your old one and check. It is like doing a tie rod on a car. Count the threads to get it close.
Once u do it should give u the correct alignment for the plate/ lever once u tighten things
Its a tedious aggravation that goes smoother with lube. May need to go in and out a few times esp if don't have old one to ballpark start it. Just be careful pulling old throw bell out don't get frustrated and break it of.
Hard to describe but hope helps some.
Posted from my iPhone/Mobile device
|