Striper Talk Striped Bass Fishing, Surfcasting, Boating - View Single Post

nightfighter · 01-27-2013, 10:37 AM

Building a jig to hold a plug while applying epoxy before transferring to spinner. Want to be able to rotate it while applying as well.

Then applying second coat to 20 plugs, since the first coat hasn't hardened enough and is just a little tacky to the touch. Not enough to leave fingerprints, but ..... Got a couple syringes to make a better measurement.

Been off the building as I have been stripping and refinishing a not quite antique pine table that is going to be an office desk for the better half. Was a wax finish that I stripped with mineral spirits and 0000 steel wool. Took a lot of time and gave off a smell like BO...... Two coats of Spar satin on the legs and stretchers. Flip later today to get second of four coat on the top.

01-27-2013, 10:37 AM	#108
nightfighter Seldom Seen iTrader: (0) Join Date: May 2001 Posts: 10,404	Building a jig to hold a plug while applying epoxy before transferring to spinner. Want to be able to rotate it while applying as well. Then applying second coat to 20 plugs, since the first coat hasn't hardened enough and is just a little tacky to the touch. Not enough to leave fingerprints, but ..... Got a couple syringes to make a better measurement. Been off the building as I have been stripping and refinishing a not quite antique pine table that is going to be an office desk for the better half. Was a wax finish that I stripped with mineral spirits and 0000 steel wool. Took a lot of time and gave off a smell like BO...... Two coats of Spar satin on the legs and stretchers. Flip later today to get second of four coat on the top. Last edited by nightfighter; 01-27-2013 at 10:43 AM..