I'm writing an
Introduction to Plug Building article for the Plum Island Surfcasters' newsletter. In it, I'd like to give instructions for building a simple saltwater lure. The assumption is the reader would not need to have access to a lathe, drill press or chop saw.
I was thinking of a cigar popper in the 1.5 oz range, with these points in mind:
- Made from a dowel
- Rear taper shaped with rasp & sandpaper(?)
- Egg sinker(s) for lead
- Screw-eyes or brass sinker eyes (like the Frech W-Y)
- Cupped face via Forstner bit or burned with carriage bolt (like Frech W-Y)
I think I'm going to recommend sealing with Helmsman. Paint would be via rattle-cans. Top coat would be clear spray lacquer.
I'm interested in any input you might have.
Thanks in advance,
Eric