Thread: Cork Flooring
View Single Post
Old 01-05-2015, 10:19 AM   #9
nightfighter
Seldom Seen
iTrader: (0)
 
nightfighter's Avatar
 
Join Date: May 2001
Posts: 10,378
Yep. Sounds like they used thinset mortar. If they did not wet the plywood, the water would have been sucked out of the mortar mix by the wood before it cured, leaving the sand and no adhesive.... Demo should be fairly easy.
Break up the tiles with a two or three pound hammer and then use a floor scraper. Then check to be sure subfloor is really fastened well to the joists. See if the floor is crowned. (use a marble) If you want to re-tile, screw down 1/4 inch sheets of hardibacker and tile on that. Just be aware you are raising the floor level so watch your thresholds and doors, if any.
nightfighter is offline   Reply With Quote