Quote:
Originally Posted by WESTPORTMAFIA
90% of the time you wont need a full clean, or rebuild. Just get it started with some carb cleaner and starter fluid and run it for 15 minutes (usually spits the tiny junk out). After that treat the BRAND NEW gas and run it every once in a while.
|
NEVER run starter fluid in a 2 stroke motor... the reason... there is no lubrication in ether...ether( starting fluid) burns uncontroled and bearings take a beating because the fuel charge is stored in the crank case... if the engine does not blow imediatly.. you are taking serious hours off of your rig...
repair kits are available at most service centers .. I order mine on line from parts tree.com...do it right.. clean the carb... mix with clean fuel and all will be fine.