Thread: Center Finder
View Single Post
Old 01-11-2017, 06:07 PM   #5
BigFish
BigFish Bait Co.
iTrader: (1)
 
BigFish's Avatar
 
Join Date: Apr 2003
Location: Hanover
Posts: 23,392
Send a message via AIM to BigFish
I made a jig for my drill press......I find center on the piece of wood, set the jig in the drill press so the bit hits center and then I tap each end with a hole about 1/4 inch deep and my chucks fit right in the holes!!

On some plugs I will for instance pre-drill the tail end as it saves me the trouble later, especially the case on metal lipped swimmers as the forward hole is usually offset drilled.

Almost time to get our fish on!!!
BigFish is offline   Reply With Quote