Striper Talk Striped Bass Fishing, Surfcasting, Boating - View Single Post

Charleston · 12-22-2004, 10:01 AM

Jig Man;
Very helpfull. One question, How are you turning (using gouge and skew) with the Vega duplicator in place? Do you have 2 lathes??
OK I guess there are two questions.

If you remove the square end on front of plug before you drill the holes, do the holes go in on an angle using only the rear square end?................oops just saw the photo!!

Sorry one more; what kind of bit did you use for the swivel/weight holes?

12-22-2004, 10:01 AM	#20
Charleston Certified Mass-hole iTrader: (0) Join Date: Jun 2003 Location: Jackson, NJ but born and raised in Massachusetts. Posts: 1,223	Jig Man; Very helpfull. One question, How are you turning (using gouge and skew) with the Vega duplicator in place? Do you have 2 lathes?? OK I guess there are two questions. If you remove the square end on front of plug before you drill the holes, do the holes go in on an angle using only the rear square end?................oops just saw the photo!! Sorry one more; what kind of bit did you use for the swivel/weight holes? Last edited by Charleston; 12-22-2004 at 01:02 PM..