Quote:
Originally Posted by nightfighter
Curious.. What is this piece to be used for? How large a hole?
Wondering if you could glue up four pieces, each with one edge eased on a table saw at 45 degrees to produce the center hole. Then turn on a larger lathe than I have. Mine is a 1014.
|
Its going to be the rear grip on a rod I'm building. I though about going with 2 8 inch piece with a thin trim band in the middle, but I'm not sure I like the idea yet. Drilling an 8 inch piece should be doable. Center hole will be around 22mm at the widest.