Striper Talk Striped Bass Fishing, Surfcasting, Boating - View Single Post

ProfessorM · 12-13-2010, 08:45 PM

http://www.striped-bass.com/Stripert...ommitizer.html

here is one G did several years back.

I just drill holes a small amount under the size of the grommet into a 3/4" dia. piece of stainless steel and insert grommet and then use a rubber hammer to slam them down into shape. Lu has a similar one but uses a mating piece over the 3/4" dia. piece so he can slam a few down at once. All work. Very simple. If this is not sufficient I will take some pics on Wed. and post.

12-13-2010, 08:45 PM	#25
ProfessorM Uncle Remus iTrader: (0) Join Date: Mar 2003 Location: Lakeville Ma. Posts: 14,773	http://www.striped-bass.com/Stripert...ommitizer.html here is one G did several years back. I just drill holes a small amount under the size of the grommet into a 3/4" dia. piece of stainless steel and insert grommet and then use a rubber hammer to slam them down into shape. Lu has a similar one but uses a mating piece over the 3/4" dia. piece so he can slam a few down at once. All work. Very simple. If this is not sufficient I will take some pics on Wed. and post.
	"A beach is a place where a man can feel he's the only soul in the world that's real"