|
What do production plug makers use for birch/maple if they don't use epoxy? Also which system 3 epoxies is anyone using for sealing or top coating?
It would seem that you would have to through wire before sealing as the holes for through wiring and tail weights would get clogged or reduced to the point where the wire would not go through or the weight would not go in if you sealed first. So far I have been sealing with 50/50 spar urethane/mineral spirits with medium success, and etex for top coating.
Last edited by fishing bum wannabe; 12-15-2017 at 02:10 PM..
|