Quote:
Originally Posted by Slipknot
Good idea doing it that way
I always have to make more since they wear out, I’ll have to try the smaller diameter first then drill with the 3/16
I think it can be almost as fast if I have two drills set up and swap out while still holding the jig in my left hand.
But I have so much scrap maple available, it is easy to make more.
I have made them for drawer front pulls also, it’s faster than measuring and marking.
Posted from my iPhone/Mobile device
|
I mark every door with the small bit before changing to 3/16 bit.
I have also used a vix bit ...self centering...to do the marking, and puts no wear on the jig
For drawer pulls it's very different... I have methods that speed up that process without an actual jig.