Striper Talk Striped Bass Fishing, Surfcasting, Boating - View Single Post

Guppy · 03-16-2017, 01:25 PM

I set up the gosa 6K at 23" from the butt, did the table top bit to set the choke point and low and behold there is no choke point.... see below

went with the 27X and a KW8 choke, then set KW's down the reduction line,,, the two stripper locations I ended up with have me puzzled, which is very easy to do seeing as though I pretty much don't know what I'm doing...:-)

also the 20 and 16 hit the reduction line but end up not quite inside what I call the KR COF

if I have a question here,,, getting dizzy,,,,, are either of the stripper locals acceptable,,, ?

gsb1201_m_table top choke.pdf

gsb1201_m_27X method.pdf

I realize this is probably way over kill with the CAD and all but,,,, I figure it's a good start, plus I'm sitting here waiting for my plotter to complete a map update....

03-16-2017, 01:25 PM	#1
Guppy User iTrader: (0) Join Date: Jun 2012 Location: Cape Cod Posts: 5,377	new 10' rod build I set up the gosa 6K at 23" from the butt, did the table top bit to set the choke point and low and behold there is no choke point.... see below went with the 27X and a KW8 choke, then set KW's down the reduction line,,, the two stripper locations I ended up with have me puzzled, which is very easy to do seeing as though I pretty much don't know what I'm doing...:-) also the 20 and 16 hit the reduction line but end up not quite inside what I call the KR COF if I have a question here,,, getting dizzy,,,,, are either of the stripper locals acceptable,,, ? gsb1201_m_table top choke.pdf gsb1201_m_27X method.pdf I realize this is probably way over kill with the CAD and all but,,,, I figure it's a good start, plus I'm sitting here waiting for my plotter to complete a map update....