whear to get 6 feet of this?

[thefishingfreak]

i need four of these
it's for dresser drawer slides.on the bottom of the drawers

[thefishingfreak]

[spence]

I would think anybody handy with a router table or table saw and the right bit/blade could fabricate that pretty easily. Don't know if you can buy it prefab...

-spence

[thefishingfreak]

ya' home depot was clueless

[spence]

Is it just a rabbit, or are the sides angled?

-spence

[Nebe]

west system epoxy and some c-clamps..... good as new.

[thefishingfreak]

it's not just this one. i need four of these.repair is not an option.
it's spozed to be square all around.
the blown out ends are from the staplegun.
just one simple pass down a piece of {insert wood here} with a very fat table saw blade it looks like

[spence]

Find someone on the board with a good table saw and proper dado blade. It shouldn't take more than 1/2 hour to make them.

Offer up one of them fancy painted plugs

-spence

[thefishingfreak]

thats why i' m posting in here

[steelhead]

Anderson & McQuade in Cambridge maybe?

[backcast]

easy to make, send me a pm if you are still interested.

[thefishingfreak]

all set guys
thanks.
mike