Flexcoat rod epoxy 4 finish?

[pbadad]

I was glueing a reel seat on a blank and had some epoxy left. I took a dark cedar A-40 and coated it. I brushed it on then took a heat gun to it. When it dried it was hard as a rock. I didn't even put a tooth mark in it. Has anyone tried or used this epoxy for plug finish?

[ProfessorM]

yes some have used it . I think it yellows easy.

[Jigman]

I've used the flex coat lite that is used for covering rod threads. Works fine. A little expensive. The times I've used it is when I had some left over after doing rod threads.

Jigman

[stripermaineiac]

I stopped uaeing Flexcoat due to how bad it yellows on Rods. Tried it on some spooks a couple yrs ago an they don't show blue over white but are now blue over yellow. Holds up good but I'd only put it over blk.

[pbadad]

Just to clarify, it's the rod epoxy for installing reel seats, ferrules, tips not the thread wrapping epoxy.

[ProfessorM]

oh, never mind. I have no knowledge of this which you speak of.