Router bit

[Striperknight]

I know is not plug building but I want to run this by all the talented woodworkers out here.

I need to replicate this molding from my brother in laws 1850 farm house.
We estimate that these moldings were made in the 1930's
I need a corner beading router bit to make this 5/8 bead.
My router only takes a 1/4 shaft bit. Can't seem to find this bit.
Any ideas?
Here is the molding:

[Striperknight]

another shot

[beachwalker]

There are bits out there that will come very close to what you want. Do you have to scarf old to new ? If not a half inch, etc. beading bit will produce a profile that can be used especially if it is linked separately within the same trim detail.

1/4' or 1/2" are almost always available if they are for a ROUTER applicaion.

check with bosch. they are found in most retail. online it's all there.

good luck

[capesams]

if you have a tablesaw you can go to sears and get a molding head ,,cutter's come in all sizes for just that purpose.