Looking for scrap or drop pieces of steel that can be welded to make mounting brackets for kicker motor controls. RJinHull has the ideas, parts and minimum equipment to get it done. (welder, drill, hack saw etc.) I cant help him from here but any of you guys around Hull Ma. know where to go?
thx BW
there used to be a welder on the street between a st and strawberry hill. it was always a crap shot as to weather he was there or not but we did a couple of small jobs for me and gave me some scrap stock to try and make jigs with.
My technician's machine shop has some stuff laying around.
~..~..~.. ><((((º>
Things done at the last possible minute are done with the greatest possible information. Procrastination is, therefore, the most efficient means of doing things.
1/8"x10"x12" would be perfect for the job. better if bent 90* on the 10" side 6" from end and drilled and painted to match boat. but he's flexible. just not familiar with the areas for his new needs.
thx for the info.
BW
You in Ma or PH Az , as that is whats listed for your location ??? (You mention Hull)
If your in Ma I can help you out and even weld it all up for you.
Both, I live in Phx, Brother lives in Hull. I visit at least once a year (late may, early june for sure) Hes getting the boat ready for my upcoming visit.
Hes trying to dash mount motor controls for the kicker. Hes just out of the loop for material.
thanks for the help
Bob W
ps I envy you guys, Its beautiful there.
just not familiar with the areas for his new needs.
Linear Mode
