|
George I use a spindle sander with a 4" sanding sleeve. Using the tenons for sliding on table fence. I do cut the top of front tenon off after lip slot is cut prior to slope.
I did use a pike 3 at first which had a shorter length until I went to the reinforced salty3. I was going to change back this time around but the guys said , NO. The testing came out good. Got the surface swimmer to work with one 7 gr weight and a 7 gr tail weight. Slowed the tail down and had a S wiggle when reeled faster. The mid with a 7 gr front weight and 11 gr rear hole. The deeps still have 2- 14gr weight slugs.
|
Threaded Mode