|
After thinking about this and talking to Dave last night I got a feeling you may have put a slightly bigger amount of the hardener in the mix just a tad too much. The small little particles that start to appear in the epoxy cup as you are applying It has happened to me on occasion and I think maybe it is starting to kick to just a very small degree. Not setting up to harden but just a wee bit of the process starting. I once talked to sys 3 about this problem and they told me to just mix it again and it will eventually disappear but it never does once it is in the mix plus you add too many bubbles into the mix if you do this. Bubbles in the mix will usually not come out either unlike e Tex which you can get out with a little heat or your breath. That does not work with this. Just a thought.
Posted from my iPhone/Mobile device
|
Threaded Mode