|
i hear ya, dennis. well, a real true test would have to involve a lot of these newer rods built as COF or large NGC for mono. then, how are the blank failures? and, how many "wind knots" would be lessened if anglers used a rod properly designed for braid vs just a COF ceramic guide layout?
i'm willing to bet that 95%+ of anglers fishing the surf today, and the vast majority on these sites, are using braid. braid today is like mono in the early-mid 90s. i don't think you can write a small article on this subject, including the braid vs mono blank failures, and have all the information. in my opinion, if you take away manufacturers blank design flaws, manufacturer rod design flaws, blems, the majority of the breaks left would be due to angler negligence. i've build tuna popping rods for BFT where the powers and pressures were much larger than in surf fishing. the only failures i received were due to the angler.
it just has always bothered me when i hear/read a rod/blank being blamed when it eventually comes out that is was in fact due to the angler. there were countless ones on another site that started as a manufacturer bashing thread when it was due to the angler, but the damage to the manufacturer's reputation was already done since most didn't read all 13 pages. again, i'm removing rods/blanks w/ design flaws.
like i said, i don't see enough advantages to fish mono over braid in the surf.
|
Threaded Mode