|
You can then put the plug on a rotator while the epoxy dries, or hang it by the nose, then flip part way through and hang by the tail. Once the epoxy has set, use a sharp knife to trim the excess flex cord from the tail of the plug. You’ll want to be able to insert the tail weight. Note that if you are not using a tail weight, you’ll trim the flex cord, then insert a tail grommet. Pull the wire out and add the swivel as you re-insert the wire. If you are adding a tail weight, you can test the weighing at this point. Once it is correct, insert the weight, add the tail grommet, and twist the wire at the back for the rear hook.
|
Threaded Mode