What's Cookin' ?

[rphud]

I have been thinking a minimal belly weight just to keep the needle hook side down and then weight at the back to get the float angle desired. Probably as small a diameter lead as will work within the length from end to hook or belly weight hole. Trying to keep as much weight in the back half for casting, but evenly distributed in the back half. Just a theory so far. Plus the selection of lead diameter is a bit limited. Smallest I am seeing is .22 inch diameter, and I would probably like to go smaller for some I am messing around with. They are only about 1/2" OD. Like a Boone needle, only heavier and thru wired and with much better hooks. Might resort to wound lead strips or wound lead wire if need be.