Need help/suggestion

[Van]

Its a pin with snap rings on both ends.

Part #31 in the diagram.

[BEETLE]

Yo Vanster,
sawzall in between the outer housing and tilt assy. Remove small peices left in outer housing once tilt is out ot the way. Remove pin left in tilt with patience, p-oil and careful application of heat
obviously new pin install.
I can see the corrosion in the pic
Like u said -hopefully upper is better. Should be.

[Van]

I don't know Steve.

I really don't want to use a sawzall. That space is really tight.
I think its too aggressive and the collateral damage will be nasty.
Cutting through an inch of stainless is not easy either.

I am hoping for a silver bullet to get that pin out intact.
If its still good, I can machine it clean here at work once out, repack and replace. Might even add a zerk fitting to keep it greased.